 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 1-1510-223-MTF
PROCEDURE
TROUBLESHOOTING
REFERENCE
SECOND ENGINE START (GPU START) (CONT)
NOTE
To reset beacon light, turn OFF approximately 5 seconds,
then ON. When voltage drops below approximately 20 volts,
the beacon light may become inoperative.
14. BEACON lights switch - Reset, then on.
BEFORE TAXIING
CAUTION
Propeller speeds below 1000 RPM are not authorized, unless
the propeller is feathered.
1.
BRAKE deice switch - Check and set as required.
To activate the brake deice system, proceed as
follows:
a.
LEFT PNEU & ENVIRO BLEED AIR valve switch
- Off.
b.
RIGHT PNEU & ENVIRO BLEED AIR valve
switch - ON.
c.
BRAKE deice switch - Turn ON and observe that
the BRAKE DE-ICE ON light is illuminated.
d.
PNEUMATIC PRESSURE gage - Check for a
momentary pressure decrease.
e.
Repeat procedure for opposite bleed air valve.
2.
CABIN AIR MODE SELECT switch - Set as
desired.
3.
CABIN AIR TEMP control rheostat - Set as
desired.
2-40
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals