APPENDIX B. IDENTIFICATION OF CALIBRATION AND REPAIR REQUIREMENTS

TB 750-25

APPENDIX B

IDENTIFICATION OF CALIBRATION AND REPAIR REQUIREMENTS

B-1. Purpose. This appendix provides instructions for using, completing, and

processing DA Form 3758-R, Calibration and Repair Requirements Worksheet (fig. B-1).

B-2. Applicability. This appendix is applicable to:

a. Commands/agencies assigned materiel management responsibilities for TMDE

used to provide maintenance support for the Army.

b. TSAs that provide TMDE C&RS.

c. DS/GS/AVIM maintenance units that provide C&RS for TMDE-SP.

d. TMDE owners/users.

e. The USATA for instruments used to provide C&RS for TMDE and processing of

DA Form 3758-R.

B-3. Use of DA Form 3758-R (fig. B-1)

a. All Army organizations must identify their TMDE calibration and repair

requirements to the USATA for inclusion in TB 43-180 to ensure subsequent C&RS. This

form also provides the USATA with information relative to changes or deletions of

previously identified calibration requirements listed in TB 43-180.

b. The form allows Army organizations to provide calibration and repair

requirements information about an instrument not listed in TB 43-180. Disposition will

be in accordance with paragraph B-5. USATA will identify and incorporate in TB 43-180

the calibration and repair requirements of instruments in the calibration standards sets

used by TSAs. Preparation will be in accordance with paragraph B-4.

NOTE

Refer to AR 750-43 for policies and responsibilities

applicable to identification of calibration and repair

requirements by TMDE materiel managers.

B-4. Preparation of DA Form 3758-R (fig. B-1). This form is divided into a header

(Control and Address) and two sections. Section A is applicable to the instrument and

its support application. Section B is applicable to calibration and repair support of the

instrument. When DA Form 3758-R is submitted as a change to, or deletion of an

existing requirement in TB 43-180, only blocks 8, 9, 11, 14, 24, and 26a - d are required to

be completed. Entries in blocks should be in accordance with the following:

B-1