Section VI. APPENDIX

inspection report on DA Form 3590 (r-request for Disposition or Waiver in

three copies If the equipment being reported IS a set, separate copies of

a Items Will all be reported to the National Inventory Control Point (NICP)

DA Form 3590 will be prepared for each major PEMA component

for disposition instructlons under the following conditions

e Equipment will not be reported for disposition solely on the basis that it

(1) The estimated one-time repair cost exceeds the prescribed ex-

penditure limits and waiver of limits IS not authorized as provided for in

IS overage Serviceable overage equipment will be retained in use unless

paragraph 4-30, AR 750-1. No action will be taken to dispose of equip-

priority of organization's mission warrants a replacement Repairs to over-

ment until dlsposition instructions are received from the NICP.

age equipment will be limited to the maintenance necessary to maintain it

(2) The repairs required to restore an item to a serviceable condition

in a safe, operable condition

are beyond the capabilities of General Support maintenance regard-

in CONUS depot stock will be determined by the

f Disposition of

less of estimated repair cost, except as provided for in b. below

NICP

b Depot repair IS authorized in oversea commands without referral lo

g Expenditure limits for all Military Standard Engines are prescribed in TB

NICP when reports can be accomplished within the prescribed expendi-

750-97-28

ture limits.

Section VI. APPENDIX

g Columns 7 through 13 - Repair Limitations. The percent of end item

11. General. The Appendix contains equipment listings and data for deter-

price, according to years, that IS authorized as a one-trme repair expendi-

mining repair eligibility, The equipment listings contain only those end items

ture The dates in columns 7 through 13 designate the final year that the

that are known to be in hands of troops or depot stock. These listings are not

percentage factors at top of columns are applicable. I terns not listed are

to be used as an identification list of the items assigned to the FSC Classes in-

not eligible for repair. except the minimum maintenance required to man-

dicated. For complete identification of FSC Group 4 materiel, refer to the ap-

tarn it in a safe, operable condition

propriate supply catalogs.

12. Explanation of Columns.

13. References.

a. Column 1-FSC or Stock Number. End item National stock numbers

AR 750-1

Army Materiel Maintenance Concepts and Policies

listed in numerical sequence

Reporting, Utilization and Distribution of Installation,

b. Column 2- Item identification Item generic nomenclature functional ca-

U S Army Materiel Command, and Oversea

pability. make and model.

Command Excess Personal Property--------------------- AR 755-1

c Column 3 - Technical Manual Number identification to End Item and

The Army Maintenance Management System (TAAMS) DA PAM 738-750

Remarks This column contains the applicable end item technical man-

Instructions for Preparation of Request for Disposition or

ual(s) identification.

TB 43-0140

d. Column 4 - Production Year. The year that item was manufactured. If no

Maintenance Expenditure Limits for Military Standard

data IS shown, refer to equipment data plate or equipment logbook.

Engines (Military Design) and Outboard Motors --- TB 750-97-28

e. Column 5 - Serial No Range

or USA Number. The serial number

Army Adapted/Other items Selected for Authorization/

ranges for the production years listed in column 4

SB 710-1-1

List of Reportable items

f. Column 6- Years of We Expectancy. The average life expectancy of the

item in years.

DD Form 1348