Section I. INTRODUCTION - TB-43-0002-350005

TB 43-0002-35

Section I. INTRODUCTION

b. Section III, Technical This section includes responsibilities

1. General.

for performing inspections on repaired or evacuated items.

a This technical bulletin implements the policies established by AR 750-

c. Section IV. Computation of Repair Cost Estimates. This section in-

1. It provides guidance for technical inspection and disposition instruc-

dudes instructions for preparing repair cost estimates for items listed.

tions.

d. Section V. Disposition instructions. This section includes disposition of

items where the repair is beyond this capability of support mainte-

nance.

e. Section VI, Appendicies. This section contains a listing of related publi-

cations referenced in this technical bulletin and expenditure limits for appli-

cable stock classes.

2. Format of Technical Bulletin. This bulletin is divided into the following:

a Section II, One-Time Repair Expenditure Limits This section includes

procedures for determining expenditure limits for items listed under certain

Federal Supply Classes.

Section II. ONE-TIME REPAIR EXPENDITURE LIMITS

4. Expenditure Limits.

3. Procedure.

a. The expenditure limit is 65 percent of the acquisition cost for compo-

a. One-time repair expenditure limits are applicable each time an item be-

nents, assemblies and recoverable repair parts applicable to the end items

comes unserviceable. The one-time repair expenditure limit is expressed

of equipment that have remaining repair eligibility cited in this bulletin. Re-

as a percentage of the total repair cost estimate to the total cost of the end

place the components, assemblies, and recoverable repair parts where

item. End item standard price is listed in the Army Master Date File

cost of repair excesses 65 percent.

(AMDF).

b. Paragraph a. above is applicable to bulk components, assemblies.

and/or recoverable repair parts to be repaired and returned to the pipeline

b. The procedure for determining the repair expenditure limit for an item is

for issue. These bulk items are those items in support of the direct ex-

as follows:

change program.

(1) Refer to the Army Master Data File (AMDF) for the current price of

c. One-Time expenditure limits are Shown in the appendicices ) as indicated

the end item.

(2) The repair cost estimate is the sum total of the estimated cost of

FSC Class 221O-Appendix B

labor and parts listed in the technical inspection repair as necessary

FSC Class 2220-Appendix C

requirements for the restoration of an end item to a serviceable condi-

FSC CIass 2230-Appendix D

tion.

NOTE

Rail items to be shipped overseas or to units for movement