|
|
TB43-0002-29
Section V. DISPOSITION INSTRUCTIONS
9. Eligibility of Materiel for Evacuation to Depot Maintenance. All equip-
b. Depot repair IS authorized in oversea commands without referral to
ment covered by this bulletin IS eligible for evacuation to depot maintenance
NICP when repairs can he accomplished within the prescribed expenditure
when the repairs required are beyond the capability of support maintenance
limits.
and the cost of repairs will not exceed the one-time repair expenditure limits.
c. Requests for disposition instructions will be prepared in accordance
with AR 755-1.
10. Disposition Instructions.
d. Report of unserviceable excess items will be accomplished by inspec-
a Items will all he reported to the National Inventory Control Point (NICP)
bon report on DA Form 3590 (RepaIr Eligibility Data Sheet) in three copies
for disposition instructions under the following conditions:
If the equipment being reported IS a set, separate copies of DA Form 3590
(I) The estimated one-time repair cost exceeds the prescribed ex-
will he prepared for each major PEMA component
penditure limits and waiver of limits is not authorized as provided for in
paragraph 4-30 and 4-31, AR 750-1. No action will he taken to dlspose
e. Equipment will not he reported for disposition solely on the basis that it
of equipment until disposition instructions are received from the NICP
IS overage. Serviceable overage equipment will be retained in use unless
(2) The repairs required to restore an item to a serviceable condition
pnonty of organization's mlssion warrants a replacement. Repairs to over-
age equipment will be limited to the maintenance necessary to maintain it
are beyond the capabilities of General Support Maintenance regard-
less of estimated repair cost, except as provided for in b below
in a safe, operable condition
Section VI. APPENDIXES
11. General. Appendix A contains equipment listings and data for determin-
e Column 5, Senal No Range, or USA Number The senal number ranges
ing repair eligibility. The equipment listings contain only those end items that
for the production years listed in Column 4
are known to be in hands of troops or depot stock. These listings are not to he
f. Column 6, Years of Life Expectancy. The estimated useful service life of
used as an identification list of the items assigned to the FSC Classes indl-
an item (in years) to the Army. This is determined by expenence with simi-
cated For complete identification of FSC Group 43 materiel, refer to the ap-
lar items considering present condition and probably future developments
propriate supply catalogs (1F)
g. Columns 7 through 13. Repair Limitations. The percent of end item
12. Explanation of Columns.
price, according to
ture. The dates in Columns 7 through 13 designate the final year that the
a Column 1. FSC or National Stock Number. End item National Stock
percentage factors at top of columns are applicable. Items not Iisted are
Numbers listed in numerical sequence
not eligible for repair, except the minimum maintenance required to main-
b Column 2, Item identification. Item generic nomenclature functional ca-
tain it in a safe, operable condition.
pability, make and model.
13. References
c Column 3, Technical Manual Number identification to End Item and Re-
marks. This column contains the applicable end item the applicable end item technical manual(e)
AR 750-1
TB 43-0140
AR 755-1
d. Column 4, Production Year. The year that item was manufactured. If no
DA PAM 738-750 SB 700-20
data is shown, refer to equipment data plate or equipment logbook.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |