Section I. GENERAL - TB-43-0002-290004

TB43-0002-29

Section I. GENERAL

Section II. ONE-TIME REPAIR EXPENDITURE LIMITS

3. Procedure.

(4) Determine the percentage factor, Columns 7 through 13, that IS

applicable for the calendar year that repair or overhaul IS required

a. One-time expenditure limits are applicable each time an item is re-

(5) Multiply the end item standard price by the percentage factor ((4)

paired. The one-time repair expenditure limit is applied against the stan-

above) to determine the one-time allowance repair costs.

dard price of the end item as listed in SB700-20

4. Expendlture Limits.

b. The procedure for determining the repair expenditure limit for an end

item, is as follows:

a The one-time expenditure limit IS a percent of the acquisition cost of the

end item, for labor, components, assemblies, and repair parts applicable

(1) Identify the item by NSN. make, model. and senal number, and

to the end items, that have remaining repair eligibility cited in this bulletin

production year. This data may be obtained from either the equipment

b. One-time expenditure limits are shown in appendix as indicated below

(2) Obtain the standard price of the item from SB 700-20.

FSC Class 4930-Appendix A

(3) Locate item in the appendix that contains the FSC Class to which

item is assigned.

Section Ill. TECHNICAL INSPECTIONS

5. Procedure. Support maintenance organizations and activities are re-

6. Forms. DA Form 3590 (Repair Eligibility Data Sheet) and DA Form 2404

(Equipment Inspection and Maintenance Worksheet) will be used to record re-

spensible for performing the technical inspections, incident to repair or evacu-

sults of technical inspections. Instructions on preparation and use of these

ation of items listed in this bulletin These inspections must be performed by

forms are found in TB 43-0140 and DA PAM 738-750, respectively.

expenenced technically qualified maintenance personnel Inspections will be

performed in accordance- with applicable equipment technical manuals and

DA PAM 738-750. When equipment is to be repaired at any level of support

maintenance, the current serviceability standards applicable to the mainte-

nance category performing the repair will apply.

Section IV. COMPUTATION OF REPAIR COST ESTIMATES

charge that are applicable are added to direct labor and direct materi-

7. Cost Factors Refer to paragraph 4-18 through 4-29 AR 750-1 for ex-

other