ASSEMBLIES/COMPONENTS/PARTS AFFECTED - TB-1-1520-240-20-1620002

TB 1-1520-240-20-162

Align hydraulic filter change intervals with system purification.

(3)

END ITEMS AFFECTED.

All H-47 Series Aircraft.

ASSEMBLIES/COMPONENTS/PARTS AFFECTED. H-47 Hydraulic Fluid System.

NOTE

When complying with the requirements of this message, complete forms and records entries IAW DA PAM

738-751. ULLS-A units will use appropriate "E" forms.

INITIAL TAMMS (THE ARMY MAINTENANCE MANAGEMENT SYSTEM) COMPLIANCE

REQUIREMENTS.

a. Upon receipt of this message, make the following entry on the DA Form 2408-13-1. Enter a Red Horizontal

Dash //-// status symbol with the following statement: "Comply with requirements of CH-47-05-ASAM-06 NLT 28

Sep 05."

NOTE

The TAMMS compliance reporting form is available at "www.redstone.army.mil/sof/tamms.xls" (use lower

case letters only) or may be obtained from the units servicing LAR. Alternate forms may be approved by the

AMCOM SOF Compliance Officer.

NOTE

The TAMMS Compliance Report only confirms the unit has made the initial logbook entry for assigned air-

craft. TAMMS Compliance Reports will include aircraft serial numbers (in numerical order), date of entry on

DA Form 2408-13-1, unit address, local POC name and phone number

b. TAMMS Compliance Report - Submit TAMMS Compliance Report via priority email to "safeadm@red-

stone.army.mil" NLT 21 Sep 05 IAW AR 95-1. If email is not available, the report may be faxed to: SOF Compliance

Officer at DSN 897-2111 or (256) 313-2111.

TASK/INSPECTION COMPLIANCE REPORTING REQUIREMENTS.

N/A.

SPECIAL PROVISIONS TO MESSAGE REQUIREMENTS (AIRCRAFT).

a. Aircraft in AVIM or Depot level maintenance - Commanders, facility managers and contractors will not issue

aircraft until they are in compliance with this message.

Aircraft at Contractor Facility - DD 250 aircraft will be in compliance with this message prior to departure.

c. Aircraft in Transit - (Surface/Air Shipment and aircraft in Ferry Status/Away From Home Station) comply with

message requirements within 14 days of arrival.

TECHNICAL PROCEDURES/INSTRUCTIONS.

NOTE

GEN-01-ASAM-04, Aviation Ground Support Equipment (AGSE) Hydraulic Fluid Contamination Control (is-

sued 4 Jun 01), and GEN-02-ASAM-01, Hydraulic Fluid Contamination Control (issued 28 Dec 01) have

NOT been rescinded or superseded by this ASAM and will remain in effect.

a. Upon receipt of this message, hydraulic fluid sampling, purification and filter change procedures are modified

as follows.