I f working on engine LDS-465-2, go to frame 3.
Put a light coat of lubricating oil on shafts and
o n all bushings in pressure pump.
P u t a light coat of lubricating oil on shafts (1 and 2) and on bushing (3).
P u t square key (4) in slot of drive impeller shaft (2).
P u t drive impeller shaft (2) in pressure pump housing (5) as shown.
T h r e a d e d end of drive impeller shaft should fit through bushing (3) in
d r i v e impeller housing.
S l i d e pressure pump driven impeller (6) over driven impeller shaft (1) and
i n t o pressure pump housing (5) as shown.
GO TO FRAME 2