 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove four screws from lighted indicator
display.
(2) Remove lighted indicator display from
instrument panel assembly.
(3) Disconnect connector PX7 from lighted
indicator display.
(4) Loosen four captive screws in lamp
mounting panel.
(5) Remove lamp mounting panel from lighted
indicator display housing.
(6) Remove transmission temperature indicator
lamps from printed circuit board.
(7) Set multimeter to ohms.
(8) Check continuity through each transmission
temperature indicator lamp and note
reading on multimeter.
(9) If continuity is not present, replace
transmission temperature indicator lamps
(para 7-16).
(10) If continuity is present, replace lighted
indicator display (para 7-16).
(11) Install transmission temperature indicator
lamps in printed circuit board.
(12) Install lamp mounting panel in lighted
indicator display housing.
(13) Tighten four captive screws in lamp
mounting panel.
(14) Connect lighted indicator display to
connector PX7.
(15) Position lighted indicator display in
instrument panel assembly with four
screws.
(16) Tighten four screws to 6-10 lb-in. (1 Nm).
(17) Connect batteries (para 7-57).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals