VOLTAGE TEST - TM-9-2320-366-20-10707

TM 9-2320-366-20-1

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle. Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.

VOLTAGE TEST

(1) Set multimeter to volts DC.

(2) Connect positive (+) probe of multimeter to

connector PX2 socket 1.

(3) Connect negative (-) probe of multimeter to

known good ground and note reading on

multimeter.

(4) Position master power switch to on

(TM 9-2320-366-10-1) and note reading on

multimeter.

(5) If 24 VDC is not present, repair wire 35

from connector PX7 pin 12 to splice E88

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(6) If 24 VDC is present, repair wire 35 from

connector J31 pin 22 to splice E88 (para

2-45) or replace WTEC II dashboard cable

assembly (para 7-10) or WTEC III dashboard

cable assembly (para 7-11)

(7) Position master power switch to off

(TM 9-2320-366-10-1).

(8) Disconnect batteries (para 7-57)

(9) Connect connector P31 to connector J31.

NOTE

Perform step (10) if vehicle is equipped with

LAMP TEST switch.

(10) Connect connector PX2 to LAMP TEST switch

connector.

(11) Install instrument panel asssembly (para 7-15).

(12) Connect batteries (para 7-57).

Change 2

2-419