Replacement. - TM-9-2320-211-20-3-10217

TM 9-2320-211-20-3-1

Replacement.

FRAME 1

Dry cleaning solvent is flammable. Do not use near an

open flame. Keep a fire extinguisher nearby when sol-

vent is used. Use only in well-ventilated places. Fail-

ure to do this may result in injury to personnel and dam-

age to equipment.

NOTE

Clean all fuel line fittings with solvent. Before putting

fittings together, put a thin coat of liquid gasket cement

on threads of fittings.

Screw in and hand tighten two elbow fittings (1 and 2) into fuel inlet solenoid

valve (3).

Using open end wrench, tighten elbow fittings (1 and 2) in fuel inlet solenoid

valve. Position each elbow fitting as noted.

Screw in and hand tighten elbow fitting (4) into the hole on the side shown of

fuel return solenoid valve (5).

Using open end wrench, tighten elbow fitting (4) in fuel return solenoid valve

(5).- Position elbow fitting as noted.

GO TO FRAME 2