 |
|||
|
|
|||
|
Page Title:
TAIL LIFT - ELECTRICAL RELAYS AND DIODE BLOCK |
|
||
| ||||||||||
|
|
 TM 5-5420-279-23
This task covers:
a. Remove
b. Install
INITIAL SETUP:
Tools Required
Tool Kit, General Mechanic's, Automotive (GMTK)
Materials Required
None
Equipment Conditions
Tail Lift deployed
Vehicle switched off and battery shutoff switch in the off position
Relay
Circuit
# from left to right
1
Swing Circuit
2
Tilt Circuit
3
Lift Circuit
4
Raise Circuit
5
Lower Circuit
a.
Remove
(1)
Remove the four screws (2) and lower the electrical junction box cover (1) on the hinges
(4).
NOTE
The electrical relays are plug-in type relays.
(2)
Note the position of the relays (6) and remove the relay (6) as required by un-plugging it
from its base.
(3)
To remove a diode from the diode block (5), note the position of the cables and disconnect
them by turning the screws on the diode block (5) counter-clockwise.
(4)
Press down on the catch (8) to remove the diode block (5).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals