FRAME 2 - TM-9-2920-225-340051

TM 9-2920-225-34

FRAME 2

Place a piece of l/8-inch thick felt over fan of rotor and fan assembly (1).

Place stator (2) over rotor and fan assembly (1) with stator leads facing fan.

Place drive end housing (3) up to stator (2).

NOTE

Have machine shop make fabricated tool. Refer to

4. Put rotor assembly tool over threaded end of shaft so that large end of tool

is against shaft shoulder. Coat shaft journal and inside diameter of lip

seal (4) with grease. Place lip seal over tool and onto shaft and take off

tool

5. With sharp edge of inner race of bearing (5) facing away from rotor (1),

press bearing onto shaft of rotor and fan assembly.

GO TO FRAME 3

TA103537

2-35