FRAME 6 - TM-9-2815-210-34-2-20807

9-2815-210-34-2-2

FRAME 6

NOTE

T h i s task is shown for engines LD-465-1, LD-465-1C,

a n d L D T - 4 6 5 - 1 C . T h i s task is the same for engines

LDS-465-1, LDS-465-1A, and LDS-465-2.

T u r n drive gear hub (2) until timing mark (3) lines up

L o o k in window (1).

with pointer (4).

L o o k in timing window (5) and check that marked tooth (6) can be seen. If

m a r k e d tooth (6) cannot be seen, turn drive gear hub (2) exactly one full

t u r n . M a r k e d tooth (6) will now be visible.

Look in window 1 again. Check that timing mark (3) is still lined up with

p o i n t e r ( 4 ) . I f they are not lined up, turn drive gear hub (2) until they

are.

L o o k in timing window (5). C h e c k that marked tooth (6) on plunger gear (7)

i s one tooth to right of pointer (8).

I f marked tooth (6) is not one tooth to right of pointer (8), plunger gear (7)

must be timed to fuel injection pump timing, device. Refer to TM 9-2910-226-34&p.

IF WORKING ON ENGINE LDS-465-1, GO TO FRAME 7.

IF WORKING ON ANY OTHER ENGINE, GO TO FRAME 9

5-177