|
|
TM 9-2815-210-34-2-2
FRAME 2
NOTE
On some e n g i n e s , oil cooler water inlet tube (1) is joined
to water p u m p ( 2 ) w i t h m o u n t i n g f l a n g e ( 3 ) . O n o t h e r- -
e n g i n e s , oil cooler water inlet tube is joined to water pump
w i t h hose (4) and clamp (5).
I f working on engine with mounting flange (3), do steps
. 1 , 2, and 3. If working on engine without mounting flange
( 3 ) , do steps 4 and 5.
1.
F o r engines with mounting flange (3), put water inlet tube (1) in place. Slide
h o s e (6) onto oil cooler water inlet (7).
2.
P u t gasket (8) in place on water pump (2). Aline flange (3) and put in four
s c r e w s with nuts and lockwashers (9).
3.
T i g h t e n two hose clamps (5).
4.
F o r engines without mounting flange (3), put w a t e r inlet tube (1) in place.
S l i d e hose (6) onto oil cooler water inlet (7).
5.
S l i d e h o s e ( 4 ) o n t o w a t e r p u m p ( 2 ) . T i g h t e n f o u r hose clamps (5).
END OF TASK
5-140
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |