FRAME 6 - TM-9-2815-210-34-2-20723

9-2815-210-34-2-2

FRAME 6

NOTE

C y l i n d e r s are called number one through six counting

f r o m front to rear of engine. Each cylinder has one

i n t a k e valve and one exhaust valve. Intake valve for

e a c h cylinder is toward front of cylinder and exhaust

v a l v e is toward rear of cylinder.

C r a n k s h a f t (1) can be turned back and forth a little

to the right or left a little bit until you are sure push

rod (2) is as high as it will go.

W a t c h push rod (2) which works cylinder number six intake valve. Turn

c r a n k s h a f t (1) one full circle to the right until push rod (2) moves up as

high as it will go.

S l i d e 0.010-inch feeler gage between cylinder number five intake rocker arm

p a d (3) and intake valve stem (4).

T u r n adjusting screw (5) until feeler gage fits snugly between cylinder

n u m b e r five intake rocker arm pad (3) and intake valve stem (4).

K e e p adjusting screw (5) from turning and tighten locknut (6).

C h e c k that 0.010-inch feeler gage still fits snugly between rocker arm pad

( 3 ) and intake valve stem (4). I f feeler gage does not fit snugly, loosen

l o c k n u t (6) and do steps 2 through 5 again.

Do steps 2 through 5 again for cylinder number one and cylinder number

f o u r intake valves.

GO TO FRAME 7

5-93