FRAME 2 - TM-9-2815-210-34-2-20662

TM 9-2815-210-34-2-2

FRAME 2

C o a t surface of crankshaft damper and pulley assembly (1) which touches

f r o n t oil seal with lubricating oil.

NOTE

To avoid overheating and damage to damper pulley

( 1 ) , use Tempilstick on rim of damper pulley.

Heat damper pulley (1) at 200F for 30 minutes.

NOTE

To make sure crankshaft damper and pulley assembly

i s properly seated, put on heated damper and pulley

a s s e m b l y , and put in and tighten retaining screw as

s o o n as possible before temperature of pulley and

crankshaft equalize.

A l i n e keyway (2) of damper pulley (1) with damper pulley locator (3).

S l i d e damper pulley (1) on crankshaft (4).

T a k e out damper pulley mounting bolt (5) and damper pulley locator (3).

IF END OF CRANKSHAFT (6) IS FLUSH WITH END OF DAMPER PULLEY BORE (7),

GO TO FRAME 7.

IF END OF CRANKSHAFT (6) IS NOT FLUSH WITH END OF DAMPER PULLEY BORE

(7) , GO TO FRAME 3

5-32