FRAME 67

TM 9-2815-210-34-2-2

FRAME 67

NOTE

Main bearing caps (1) with bearing halves (2) and main

b e a r i n g saddles (3) are called by numbers one to seven

c o u n t i n g from front to rear of crankcase (4).

N u m b e r seven main bearing cap has a slot (5) on each

s i d e for rubber oil seal.

P u t number seven main bearing cap (1) with bearing half (2) on number

s e v e n main bearing saddle (3). M o u n t i n g holes in number seven main bearing

c a p must line up with screw holes in number seven bearing saddle.

C o a t two bolts (6) and washers (7) lightly with engine lubricating oil. Put

i n and hand tighten two bolts and washers.

Using torque wrench, tighten two bolts (6) to 80 to 90 pound-feet.

U s i n g torque wrench, tighten two bolts (6) to 115 to 120 pound-feet.

GO TO FRAME 68

4-91