Removal of Expansion Plugs and Crankcase to Cylinder Head Studs. (cont)

TM 9-2815-210-34-2-2

FRAME 2

NOTE

Cylinder sleeves (1) are usually thrown away, but

c y l i n d e r sleeves that are almost new may be used

a g a i n . Mark cylinder sleeves to be used again so

that they will be put back in the same position in

t h e same crankcase (2) cylinder bore.

C h e c k if hone pattern can be seen in ring travel area in each of six cylinder

s l e e v e s (1) as shown. If hone pattern can be seen and there is no groove

w o r n at top of ring travel area, mark cylinder sleeve and crankcase (2) with

s c r i b e mark (3) as shown. If hone pattern cannot be seen, or if a groove is

w o r n at top of ring travel area, mark cylinder sleeve to be thrown away.

U s i n g stud remover, take out all crankcase to cylinder head studs (4).

GO TO FRAME 3

4-8