|
|
TM 9-2815-210-34-2-1
NOTE
T e l l machine shop to make pilot stud (1). See figure
3-3.
1.
P u t pilot stud (1) in hole of flywheel (2) as shown.
Soldier A 2.
U s i n g engine barring tool, hold crankshaft damper and pulley (3)
s o it cannot turn to the right.
Soldier B 3.
H o l d flywheel (2) against crankshaft so it will not fall when lock-
b o l t s (4) are taken out. W h i l e holding flywheel against crankshaft,
take out five lockbolts (4).
Soldiers
4.
H o l d up flywheel (2) and slide it back clear of pilot stud (1) and
A and B
take it off. Set flywheel down on wooden blocks.
Soldier A 5.
T a k e out pilot stud (1).
END OF TASK
TA 087690
3-145
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |