|
|
TM 9-2815-210-34-2-1
FRAME 4
NOTE
F u e l injection pump (1) shown is for engines LD-465-1,
L D - 4 6 5 - 1 C , and LDT-465-1C. This task is the same
for other engines.
H a v e machine shop make holding wrench (2). See
1.
J o i n holding wrench (2) to fuel injection pump drive gear hub (3) using two
screws (4) as shown.
2.
Take off nut (5).
T a k e out two screws (4) and take off holding wrench (2).
3.
Pull off drive gear hub (3).
4.
P u t nut (5) back on fuel pump driveshaft (6).
5.
END OF TASK
3-39
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |