Installation. - TM-9-2320-366-20-31109

TM 9-2320-366-20-3

b. Installation.

(1) Position terminal lug TL12 (1) on starter solenoid (2) with

nut (3).

(2) Tighten nut (3) to 15-20 lb-ft (20-27 Nm).

WARNING

Adhesives, solvents, and sealing com-

pounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. Keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing compound

gets on skin or clothing, wash

immediately with soap and water. Failure

to comply may result in injury to

personnel.

(3) Apply adhesive to terminal lug TL12 (1) on starter

NOTE

Both clamps are installed the same way.

One shown.

(4) Install two clamps (4) on battery to starter cable

assembly (5).

NOTE

Steps (5) through (7) require

the aid of an assistant.

(5) Position battery to starter cable assembly (5) on frame

rail (6) with clamp (4), screw (7) and self-locking nut (8).

(6) Perform Step (5) on remaining clamp.

NOTE

Install plastic cable ties as required.

(7) Tighten two self-locking nuts (8) to 97-124 lb-in. (11-14

Nm).

Change 1

7-353