Installation. - TM-9-2320-366-20-31098

TM 9-2320-366-20-3

7-73. 100 AMP ALTERNATOR TO REVERSE POLARITY RELAY 24 VDC CABLE

REPLACEMENT (CONT)

b. Installation.

(1) Install three clamps (1) on 100 amp alternator to reverse

polarity relay 24 vdc cable (2).

NOTE

Install plastic cable ties as required.

(2) Position 100 amp alternator to reverse polarity relay 24

vdc cable (2) on engine (3) with three clamps (1),

washers (4), and screws (5).

(3) Tighten three screws (5) to 22-27 lb-ft (31-37 Nm).

(4) Install 100 amp alternator to reverse polarity relay 24 vdc

cable (2) in dust boot (6).

CAUTION

Insulation washer must be installed with flat

side up. Failure to comply may result in

damage to equipment.

(5) Position terminal lugs TL6 (7) and TL2 (8) on alternator

(9) with insulation washer (10), washer (11) and

self-locking nut (12).

(6) Tighten self-locking nut (12) to 40 lb-in. (5 Nm).

(7) Position dust boot (6) on terminal lugs TL2 (8) and TL6

(7).

7-342