|
|
TM 9-2320-366-20-3
7-15. INSTRUMENT PANEL ASSEMBLY REPLACEMENT/REPAIR (CONT)
NOTE
Perform steps (20) through (22) on vehicles
equipped with WTEC III transmission
controls.
(20) Install WTEC III TPSS (29) in instrument panel (2).
(21) Position two brackets (30) on rear of WTEC III TPSS
(29) with two nuts (31).
(22) Tighten two nuts (31) to 11-13 lb-in. (1.3-1.5 Nm).
NOTE
All electrical gages are installed the same
way. FUEL gage shown.
(23) Position FUEL gage (32) in instrument panel (2) with
mounting ring (33) and two self-locking nuts (34).
(24) Tighten two self-locking nuts (34) to 9 lb-in. (1 Nm).
(25) Install two protective caps (35) on FUEL gage (32).
(26) Perform steps (23) through (25) on remaining gages.
7-104
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |