Installation. (cont) - TM-9-2320-366-20-30713

TM 9-2320-366-20-3

CAUTION

Clamp tongue must be started in clamp groove.

Failure to comply may result in damage to

equipment.

Position clamps so that screws will be toward

center of vehicle and angled down.

(3) Position two clamps (2) on lower coolant hose (6).

(4) Install lower coolant hose (6) between radiator (7) and

transmission oil cooler (8).

(5) Engage as many clamp tabs (4) as possible in tab

windows (5) allowing little or no play between clamp and

lower coolant hose (6).

(6) Tighten two clamps (2) to 12-18 lb-in. (1-2 Nm).

NOTE

Minimum allowable gap on clamp is 0.2 in.

(0.5 cm). If gap is less than 0.2 in. (0.5 cm),

remove and re-install clamp.

(7) Measure gap on two clamps (2).

6-57