 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-3
TM
WARNING
Wear approved eye protection when
performing pressure checks. Failure
to comply may result in oil getting
into eyes. If oil contacts eyes, seek
medical attention immediately.
Fuel and oil are slippery and can
cause falls. Wipe up spilled fuel
or oil with rags. Failure to comply
may result in injury to personnel.
V1 PRESSURE TEST
(1)
If stiffleg has failed in an off-the-ground
position, place trestle under foot of stiffleg
before doing tests.
(2)
Open box lid over affected stiffleg and slide
off cylinder cover.
(3)
Disconnect UP pressure hose at V1 port of
affected stiffleg cylinder.
(4)
Cap V1 fitting on top of cylinder.
(5)
Connect STE/ICE-R transducer and adapter onto
end of disconnected UP pressure hose.
(6)
Start engine (TM 9-2320-366-10-1).
(7)
Position PTO switch to on (TM
9-2320-366-10-1).
(8)
Perform STE/ICE-R test # 51.
(TM 9-4910-571-12&P).
(9)
Momentarily position stiffleg lever for affected
stiffleg to UP position, release lever.
(10)
Observe pressure reading. If pressure is
below 3000 psi (20,685 kPa), notify DS
Maintenance.
(11)
Position PTO switch to off (TM
9-2320-366-10-1).
(12)
Shut down engine (TM 9-2320-366-10-1).
(13)
Disconnect STE/ICE-R from UP pressure hose.
(14)
Remove cap from V1 fitting on top of
cylinder.
(15)
Connect UP pressure hose to V1 port of
cylinder.
(16)
Close box lid cover over affected stiff
leg cylinder.
(17)
Remove trestle if required.
2-2251
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals