|
|
TM 9-2320-366-20-3
TM
WINCH CONTROL VALVE PRESSURE TEST
(1)
Disconnect hose from fitting below elbow
at port V1 (on side of 15K self-recovery winch
toward front of vehicle).
(2)
Connect STE/ICE-R with tee between port
V1 and hose.
(3)
Start engine (TM 9-2320-366-10-1).
(4)
Attach stall load to winch cable
(TM 9-2320-366-10-1).
(5)
Position PTO switch and WINCH POWER
switch to ON (TM 9-2320-366-10-1).
(6)
Engage winch clutch (TM 9-2320-366-10-1).
(7)
Perform STE/ICE-R test #51 and toggle
WINCH IN/OUT switch to IN position and hold
(TM 9-4910-571-12&P).
(8)
Check if pressure reading is between
2450-2600 psi (16893-17927 kPa) on
STE/ICE-R.
(9)
If pressure is less than 2600 psi, notify DS
Maintenance.
(10)
Position WINCH POWER and PTO switches
to off (TM 9-2320-366-10-1).
(11)
Shut down engine (TM 9-2320-366-10-1).
(12)
Disconnect STE/ICE-R and tee.
(13)
Connect hose fitting to port V1.
(14)
Disconnect hose (below elbow) from port V2.
(15)
Connect STE/ICE-R with tee between hose and
port V2.
(16)
Start engine (TM 9-2320-366-10-1).
(17)
Position PTO and WINCH POWER switches
to on (TM 9-2320-366-10-1).
(18)
Perform STE/ICE-R test #51 and toggle
WINCH IN/OUT switch to OUT (TM 9-4910-
571-12&P).
(19)
Check if pressure reading is between 2450-
2600 psi (16893-17927 kPa).
(20)
If pressure is lower than 2450 psi, notify DS
Maintenance.
(21)
Release load and retrieve cable
(TM 9-2320-366-10-1).
(22)
Position WINCH POWER and PTO switches to
off (TM 9-2320-366-10-1).
(23)
Disengage winch clutch (TM 9-2320-366-10-1).
(24)
Shut down engine (TM 9-2320-366-10-1).
(25)
Disconnect STE/ICE-R and tee.
(26)
Connect hose fitting to port V2.
2-2209
2-2209
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |