 |
|||
|
|
|||
|
Page Title:
TIRE PRESSURE MEASUREMENT |
|
||
| ||||||||||
|
|
 TM 9-2320-366-20-3
TM
WARNING
Wear appropriate eye protection
when working under vehicle and
around CTIS due to the
possibility of falling or
blown debris. Failure to comply
may result in injury to personnel.
CAUTION
When RUN FLAT has been
selected to perform a
troubleshooting step, be
sure to press RUN FLAT
again when step is
completed to terminate
CTIS operation and
prevent excessive air
loss.
NOTE
Four mode lights flashing
indicate CTIS has shut off
due to uneven tire pressure
(one tire 50 percent less than
other pressures will do it),
tire damage, or major leak.
Operator can continue CTIS
operation by pressing RUN
FLAT on CTIS ECU. When RUN
FLAT has been selected
CTIS ECU checks pressures
at 15 second
intervals.
TIRE PRESSURE MEASUREMENT
(1)
Measure and record the tire pressure
of each tire (TM 9-2320-366-10-1).
(2)
If any tire pressure is lower than the rest,
visually inspect tire for damage.
(3)
Apply soapy water solution to tire
bead.
(4)
Observe tire for bubbles indicating
leaks.
2-2043
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals