 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Disconnect connector clamp from connector
P116.
(2) Disconnect connector P116 from WTEC
III ECU.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector PX33 socket R.
(5) Connect negative (-) probe of multimeter to
connector P116 socket 16 and note reading
on multimeter.
(6) If continuity is not present, repair wire 136
from connector PX33 socket R to connector
P116 socket 16 (para 2-45) or replace WTEC
III dashboard cable assembly (para 7-11).
(7) If continuity is present, replace WTEC III
ECU (para 8-7).
(8) Connect connector PX33 to WTEC III TPSS.
(9) Install instrument panel assembly (para 7-15).
Change 1
2-1822.29/(2-1822.30 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals