 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CONTINUITY TEST
(1) Remove kick panel (para 16-3).
(2) Disconnect connector clamp from
connector P115.
(3) Disconnect connector P115 from WTEC III
transmission ECU.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to connector P115-1.
(6) Connect negative (-) probe of multimeter to
all other sockets in connector P115 (except
P115-16), one at a time, and note reading
on multimeter.
(7) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(8) Connect positive (+) probe of multimeter
to connector P115-16.
(9) Connect negative (-) probe of multimeter to
all other sockets in connector P115 (except
P115-1), one at a time, and note reading on
multimeter.
(10) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(11) If continuity is present repair wire 136
(para 2-45) or replace WTEC III dashboard
cable assembly (para 7-11).
Change 1
2-1809
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals