 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
RESISTANCE TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) prove of multimeter
to connector P119h.
(3) Connect negative (-) probe of multimeter to
connector P119j and note reading on
multimeter.
(4) If resistance is high (20,000 ohms or
higher), replace WTEC III transmission ECU
(para 8-7).
(5) If resistance is low (less than 20,000
ohms), notify DS maintenance.
(6) Install instrument panel assembly (para
7-15).
(7) Connect connector P119 to connector
J119.
(8) Position front grille on cab with washer
and screw.
(9) Position two washers and screws in front
grille.
(10) Tighten screw to 48-60 lb-in. (5-7 Nm).
(11) Tighten two screws to 24 lb-in. (3 Nm).
(12) Connect connector P114 to WTEC III
transmission ECU.
(13) Connect connector clamp on connector
P114.
(14) Install kick panel (para 16-3).
(15) Clear diagnostic codes (para 8-5).
Change 1
2-1757
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals