 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Loose or dirty connectors may cause
intermittent loss of power to transmission
ECU and diagnostic codes to be logged.
Ensure that all connectors are clean and tight
before performing troubleshooting. Failure to
comply may result in incorrect test results.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Remove two screws and washers from
front grille.
(2) Remove screw and washer from front grille.
(3) Remove front grille on cab.
(4) Disconnect connector P119 from connector
J119.
(5) Remove kick panel (para 16-3).
(6) Disconnect connector clamp from
connector P114.
(7) Disconnect connector P114 from WTEC III
transmission ECU.
(8) Set multimeter to ohms.
(9) Connect positive (+) probe of multimeter
to connector J199h.
(10) Connect negative (-) probe of multimeter to
connector P114-13 and note reading on
multimeter.
(11) If continuity is not present, replace WTEC
III cab transmission harness (para 7-138).
Change 1
2-1753
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals