 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1)
Loosen screw in connector J116.
(2)
Disconnect connector J116 from WTEC II
VIM.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter to
WTEC II connector pin J1.
(5)
Connect negative (-) probe of multimeter to
WTEC II connector pin R1 and note reading
on multimeter.
(6)
If continuity is not present, go to step
12 of this fault.
Change 1
2-1706.23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals