 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors
not to bend connector pins or damage
connector sockets with multimeter probes.
Failure to comply may result in damage
to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector J116 socket A1.
(3) Connect negative (-) probe of multimeter
to connector J115 socket 9 and note
reading on multimeter.
(4) Connect negative probe (-) of multimeter
to all other sockets in connector J115
and note reading on multimeter.
(5) Connect negative probe (-) of multimeter
to ground and note reading on multimeter.
(6) If continuity is not present in step (3), or
continuity is present in step (4) or step (5),
replace WTEC II cab transmission harness
(para 7-137).
(7) If continuity is present in step (3) and
continuity is not present in step (4) or (5),
replace WTEC II TEPSS (para 8-2).
(8) Connect connector J116 to VIM
connector.
(9) Tighten screw in connector J116.
(10) Connect connector J115 to WTEC II
TEPSS connector.
(11) Install kick panel (para 16-3).
(12) Install instrument panel assembly
(para 7-15).
(13) Clear diagnostic codes (para 8-4).
Change 1
2-1706.15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals