 |
|||
|
|
|||
|
Page Title:
CONTINUITY TEST |
|
||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors
not to bend connector pins or damage
connector sockets with multimeter probes.
Failure to comply may result in damage
to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Remove kick panel (para 16-3).
(2) Loosen screw in PX33 connector.
(3) Disconnect connector PX33 from VIM
connector.
(4) Set multimeter to volts DC.
(5) Connect positive (+) probe of multimeter
to connector PX33 socket J1.
(6) Connect negative (-) probe of multimeter
to a known good ground and note reading
on multimeter.
(7) Connect positive (+) probe of multimeter
to connector PX33 socket J2.
(8) Connect negative (-) probe of multimeter
to a known good ground and note reading
on multimeter.
(9) If 12 VDC is not present in steps (5) and
(7), repair wire 1900 (para 2-45) or replace
WTEC II dashboard cable assembly
(para 7-10).
Change 1
2-1706.5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals