 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CONTINUITY TEST
(1)
Disconnect connector J115 (top
connector) from WTEC II TEPSS.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter
to connector J114-24.
(4)
Connect negative (-) probe of multimeter to
all other sockets in connector J114, one at
a time, and all sockets in connector J115,
one at a time, and note readings on
multimeter.
(5)
Connect positive (+) probe of multimeter
to connector J115-1.
(6)
Connect negative (-) probe of multimeter to
all other sockets in connector J115, one at
a time, and all sockets in connector J114,
one at a time, and note readings on
multimeter.
(7)
Connect positive (+) probe of multimeter
to connector J115-22.
(8)
Connect negative (-) probe of multimeter to
all other sockets in connector J115, one at
a time, and all sockets in connector J114,
one at a time, note readings on multimeter.
(9)
If continuity is present in step 4, 6, or 8,
replace WTEC II cab transmission harness
(para 7-137).
(10)
If continuity is not present in step 4, 6, and 8,
replace WTEC II TEPSS (para 8-2).
(11)
Connect connector J114 (bottom connector)
to WTEC II TEPSS.
(12)
Connect connector J115 (top connector) to
WTEC II TEPSS.
(13)
Install instrument panel assembly (para 7-15).
(14)
Connect connector P119 to connector J119.
(15)
Position front grille on cab with washer and
screw.
(16)
Position two washer and screws in front
grille.
(17)
Tighten screw to 48-60 lb-in. (5-7 Nm).
(18)
Tighten two screws to 24 lb-in. (3 Nm).
(19)
Clear diagnostic codes (para 8-4).
Change 1
2-1667
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals