|
|
TM 9-2320-366-20-2
RESISTANCE TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) prove of multimeter to
connector P119h.
(3) Connect negative (-) probe of multimeter to
connector P119j and note reading on
multimeter.
(4) If resistance is high (20,000 ohms or
higher), replace WTEC II TEPSS (para 8-2).
(5) If resistance is low (less than 20,000
ohms), notify DS Maintenance.
(6) Connect connector J115 to WTEC II
TEPSS.
(7) Install instrument panel assembly
(para 7-15).
(8) Connect connector P119 to connector
J119.
(9) Position front grille on cab with washer
and screw.
(10) Position two washers and screws in front
grille.
(11) Tighten screw to 48-60 lb-in. (5-7 Nm).
(12) Tighten two screws to 24 lb-in. (3 Nm).
(13) Clear diagnostic codes (para 8-4).
Change 1
2-1639
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |