 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
RESISTANCE TEST
(1) Remove two screws and washers from
front grille.
(2) Remove screw and washer from front
grille.
(3) Remove front grille from cab.
(4) Disconnect connector P119 from
connector J119.
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to connector P119 pin m.
(7) Connect negative (-) probe of multimeter
to connector P119 pin s and note reading
on multimeter.
(8) Connect negative (-) probe of multimeter
to all other pins in connector P119 and
note reading on multimeter.
(9) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(10) If 200-400 ohms resistance is not present
in step 7, or continuity is present in step 8
or step 9, notify DS Maintenance.
Change 1
2-1589
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals