 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Remove six screws from auxiliary panel.
(2) Lift auxiliary panel from auxiliary panel
housing to gain access.
(3) Disconnect connector P905 from
worklights switch.
(4) Set multimeter to volts DC.
(5) Connect positive (+) probe of multimeter
to connector P905 socket 5.
(6) Connect negative (-) probe of multimeter
to ground.
(7) Position main light switch to STOP LIGHT
(TM 9-2320-366-10-1) and note reading
on multimeter.
(8) If 12 VDC is not present, go to step 7 of
this fault.
(9) Position main light switch to OFF
(TM 9-2320-366-10-1).
Change 1
2-1541
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals