 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
(1) Check if vehicle is M1088 W/O winch.
(2) If vehicle is not an M1088 W/O winch, go to step
7 of this fault.
(3) If vehicle is an M1088 W/O winch, go to step 9
of this fault.
CONTINUITY TEST
(1)
Remove personnel heater for access
(para 18-9).
(2)
Disconnect connector P912 from connector
J912.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter to
relay K15 socket 87A.
(5)
Connect negative (-) probe of multimeter to
connector P912-15 and note reading on
multimeter.
(6)
If continuity is not present, repair wire 1811
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7)
Install relay K15 in PDP.
2-1535
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals