 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove relay K15 from PDP.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
relay K15 socket 30.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 24 vdc is not present, repair wire 1808
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7)
Position master power switch to off
(TM 9-2320-366-10-1).
(8)
Install circuit breaker CB22 in PDP.
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
relay K15 pin 30.
(3)
Connect negative (-) probe of multimeter to
relay K15 pin 87A and note reading on
multimeter.
(4)
If continuity is not present, replace relay K15
(para 7-9).
2-1513
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals