 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to DUMP BED UP/DOWN switch terminal 3.
(3) Connect negative (-) probe of multimeter
to DUMP BED UP/DOWN switch terminal 1.
(4) Press and hold DUMP BED UP/DOWN
switch to DOWN and note reading on
multimeter.
(5) If continuity is not present, replace DUMP
BED UP/DOWN switch (para 7-18).
(6) Release DUMP BED UP/DOWN switch.
(7) Install circuit breaker CB50 in PDP.
Change 1
2-1501
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals