 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1)
Remove six screws from auxiliary panel.
(2)
Lift auxiliary panel outward to gain access.
(3)
Disconnect connector P910 from tailgate
release switch.
(4)
Set multimeter to volts DC.
(5)
Connect positive (+) probe of multimeter
to connector P910 socket 3.
(6)
Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(7)
If 24 VDC is not present, repair wire 2006
from connector P910 socket 3 to connector
P912 socket 1 (para 2-45) or replace
auxiliary panel cable assembly (para 7-58).
Change 1
2-1473
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals