 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Wear protective goggles to protect against
possible injury from release of high pressure
air. Failure to comply may result in injury to
personnel.
AIR PRESSURE TEST
(1) Install circuit breaker CB50 in PDP.
(2) Open LH and RH catwalks.
(3) Disconnect air hose from pneumatic
manifold solenoid L17 port 1.
(4) Start engine (TM 9-2320-366-10-1).
(5) Position MAIN WINCH RH FREESPOOL
switch to ON.
(6) If air pressure is not present at pneumatic
manifold solenoid L17 port 1, go to step 11
of this fault.
(7) If air pressure is present at pneumatic
manifold solenoid L17 port 1, perform
Wrecker Air System Troubleshooting task
aa3. Main Winch RH Freespool Does Not
Operate.
(8) Position MAIN WINCH RH FREESPOOL
switch to OFF.
(9) Shut down engine (TM 9-2320-366-10-1).
(10) Connect air hose to pneumatic manifold
solenoid L17 port 1.
NOTE
Perform steps (11) and (13) if air pressure
is present at air hose.
(11) Close LH and RH catwalks.
(12) Install PDP cover (para 16-2).
(13) Install wrecker control panel top cover
(para 14-4).
Change 1
2-1456.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals