 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Set engine speed to idle (750 rpm) by
decreasing HAND THROTTLE lever to full
down position.
(2) Position PTO switch to off.
(3) Shut down engine (TM 9-2320-366-10-1).
(4) Position MAIN WINCH LH FREESPOOL
switch to OFF.
(5) Position MAIN WINCH RH FREESPOOL
switch to ON.
(6) Set multimeter to volts DC.
(7) Connect positive (+) probe of multimeter
to terminal block TB18.
(8) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(9) If 24 VDC is not present, replace MAIN
WINCH RH FREESPOOL switch (para 7-34)
and M1089 wrecker control panel wiring
harness (para 7-83).
(10) Position MAIN WINCH RH FREESPOOL
switch to OFF.
Change 1
2-1455
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals