 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Install circuit breaker CB50 in PDP.
(2) Position MAIN WINCH RH SPEED switch to
HIGH.
(3) Set multimeter to volts DC.
(4) Connect positive (+) probe of multimeter
to terminal block TB12.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) If 24 VDC is not present, replace MAIN
WINCH RH SPEED switch (para 7-34) and
M1089 control panel wiring harness
(para 7-83).
(7) If 24 VDC is present, replace M1089 30K
winch control wiring harness (para 7-142).
(8) Position MAIN WINCH RH SPEED switch to
LOW.
(9) Close LH and RH catwalks.
(10) Install PDP cover (para 16-2).
(11) Install wrecker control panel top cover
(para 14-4).
Change 1
2-1450.9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals