 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Goggles must be worn while operating
wrecker control panel. Blowing dust and
debris may become airborne while engine is
running. Failure to comply may result in
injury to personnel.
OPERATIONAL TEST
(1) Position MAIN WINCH LH SPEED switch to
LOW.
(2) Position MAIN WINCH LH lever to IN until
cable is fully recovered.
(3) Position MAIN WINCH RH SPEED switch to
LOW.
(4) Position MAIN WINCH RH FREE SPOOL
switch to OFF.
(5) Position MAIN WINCH RH lever to OUT
until the first five wraps of cable have
pay-out.
(6) Position MAIN WINCH RH SPEED switch to
HIGH.
(7) Position MAIN WINCH RH lever to OUT and
note speed of winch.
(8) If RH 30K winch does not operate at high
speed, go to step 9 of this fault.
(9) Position MAIN WINCH RH SPEED switch to
LOW.
(10) Position MAIN WINCH RH lever to IN until
cable is fully recovered.
(11) Set engine speed to idle (750 rpm) by
decreasing HAND THROTTLE lever to the
full down position.
(12) Position PTO switch to off.
(13) Shut down engine (TM 9-2320-366-10-1).
Change 1
2-1450.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals