 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Disconnect connector P108 from connector
J108.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector P108-18.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 24 vdc is not present, repair wire 2006
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7)
If 24 vdc is present, repair wire 2006 (para
2-45) or replace rear lights cable assembly
(para 7-104).
(8)
Position master power switch to off
(TM 9-2320-366-10-1).
(9)
Connect connector P108 to connector J108.
(10)
Install personnel heater (para 18-9).
(11)
Install top control panel cover (para 17-20).
2-1431
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals