|
|
TM 9-2320-366-20-2
TM
CONTINUITY TEST
(1)
Disconnect swing CCW solenoid connector
from swing CCW solenoid.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter on pin
2 of swing CCW solenoid cable connector.
(4)
Connect negative (-) probe of multimeter on
ground and note reading on multimeter.
(5)
Connect positive (+) probe of multimeter on pin
1 of swing CCW solenoid cable connector.
(6)
Connect negative (-) probe of multimeter on
terminal board lower position 9 and note
reading on multimeter.
(7)
If continuity is not present, replace swing
CCW solenoid cable (para 7-119).
(8)
If continuity is present, notify DS Maintenance.
(9)
Connect swing CCW solenoid cable connector
to swing CCW solenoid.
(10)
Close cover on junction box.
(11)
Tighten four screws on junction box cover.
(12)
Stow crane (TM 9-2320-366-10-1).
2-1393
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |