OUTPUT VOLTAGE TEST - TM-9-2320-366-20-20515

TM 9-2320-366-20-2

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry beffore working around

vehicle. Jewelery can catch on equipment and

cause injury or short circuit across electrical

circuits and cause severe burns or electrical

shock.

OUTPUT VOLTAGE TEST

(1)

Connect external remote control cable to

remote control box (TM 9-2320-366-10-1).

(2)

Loosen four screws on junction box.

(3)

Open cover on junction box.

(4)

Position MAIN POWER switch to ON.

(5)

Lift guard and position remote control box

ON/OFF switch to ON.

(6)

Set multimeter to volts dc.

(7)

Connect positive (+) probe of multimeter on

terminal board lower position 9.

(8)

Connect negative (-) probe of multimeter on

ground quick-connect terminal board

(above MAIN POWER switch).

NOTE

Step (9) requires the aid

of an assistant.

(9) Position SWING CW/CCW controller to CCW

and note reading on multimeter.

(10) If 24 volts dc is not present, go to step 3 of

this fault.

(11) Position MAIN POWER switch to OFF.

2-1391